The Emissions You Can See Only in Tracking: Dock Dwell, Detention and Idling at US Stops (2026)

Dock dwell is the time a truck or van spends at a stop without moving, and idling is the fuel it burns while it waits. Distance-based emissions figures miss both, because the vehicle has gone no further. Only tracking that records arrival, departure and, where available, engine state can show how much time and fuel a stop consumes.
This guide sets out what the published data says, what tracking can and cannot see, and where Locus, the world’s first Decision-Intelligent, Agentic TMS, fits.
Key Takeaways
- ATRI’s 2024 study reports that drivers were detained in 39.3% of all stops in 2023, and the release gives no duration for that figure.
- DOE says idling a heavy-duty truck consumes about 0.8 gallons of fuel per hour, and EPA’s factor for diesel is 10.21 kg of CO2 per gallon, so an hour of idling is about 8.2 kg of CO2.
- A University of Washington study of urban commercial vehicles found that, on average, they spent 80% of their daily operating time parked, in a small Seattle sample.
- Phone GPS can show when a vehicle arrived and left, but engine hours come from the vehicle’s engine computer through an electronic logging device or telematics.
- State idling rules differ: California and New York State set five minutes, and New York City sets three, with exemptions that rarely cover simply waiting.
Why Does Waiting Matter for Cost and Emissions? The Business Case
The published figures describe truckload detention and idling fuel, and none is a measure of van last-mile dock waits.
- The American Transportation Research Institute reports that drivers were detained in 39.3 percent of all stops in 2023, and that 94.5 percent of fleets charge detention fees but are paid on fewer than 50 percent of those invoices.
- The same ATRI release says the time lost to detention in for-hire trucking exceeded 135 million hours in 2023, with $3.6 billion in direct expenses and $11.5 billion in lost productivity.
- The US Department of Energy’s fact sheet says that idling a heavy-duty truck consumes about 0.8 gallon of fuel per hour, for long-haul trucks.
- The EPA’s emission factors hub gives 10.21 kg of CO2 per gallon of diesel in its 2025 edition.
- The University of Washington’s Urban Freight Lab found from ride-alongs that urban commercial vehicles spent 80 percent of their daily operating time parked, in 6 ride-alongs and 79 stops in Seattle.
ATRI’s page does not define “detained” or give a duration for the 39.3%, and the full report is behind a form. The figures are for for-hire trucking in 2023, and the Washington figure measures parked time, not idling. We found no newer US detention release.
How Do You Measure Dock Dwell and Idling in Six Steps?
The six steps turn tracking events into hours, fuel and CO2. Each assumption is yours to replace.
1. Define the events
Decide what counts as arrival, dock-in, dock-out and departure at each facility. Write the definition down.
2. Check that your geofences can fire
A geofence detects arrival only if the location updates arrive often enough. Test it against a known visit.
3. Add engine state where you can
Phone GPS shows position. Engine-on time needs the engine computer, through an electronic logging device or telematics.
4. Measure dwell by facility
Report dwell per stop and per facility, not only per route. A few sites usually account for most of the waiting.
5. Convert idle hours to fuel and CO2
Use a stated gallons-per-hour figure and the EPA factor, and label the result illustrative.
6. Act on the cause
Link long dwell to appointment windows, load readiness and the promised delivery slot, and check state idling rules.
What Does One Hour of Waiting Cost in Fuel and CO2? An Illustration
The table applies DOE’s 0.8 gallons per hour and EPA’s 10.21 kg of CO2 per gallon. The arithmetic is ours.
| Idle wait | Diesel burned | CO2 |
|---|---|---|
| 30 minutes | 0.4 gallons | 4.08 kg |
| 1 hour | 0.8 gallons | 8.17 kg |
| 2 hours | 1.6 gallons | 16.3 kg |
| 4 hours | 3.2 gallons | 32.7 kg |
The 0.8 gallons is for a heavy-duty long-haul truck idling, so it does not describe a delivery van or a truck with its engine off. We found no medium- or light-duty rate from a primary source. The factors are tank-to-wheel CO2 for diesel.
What Can Tracking See and What Can’t It?
The table separates what each data source can show. It draws on GPS.gov, 49 CFR 395.26 and the studies above.
| Question | Phone GPS tracking | ELD or telematics | Facility records |
|---|---|---|---|
| When did the vehicle arrive and leave? | Yes, within about 5 meters in open sky | Yes | Yes, as check-in times |
| Was the engine running? | No | Yes, from engine hours | No |
| How long was it at the dock? | Only if the geofence fires | Yes | Yes, for dock-in and dock-out |
| How much fuel was burned? | No | Partly, with a fuel feed | No |
| Why did it wait? | No | No | Partly, from appointment and load status |
GPS.gov says smartphones are typically accurate to within 4.9 meters under open sky, and worse near buildings. The federal ELD rule records engine hours for drivers who must keep hours-of-service records, which excludes many last-mile vans.
What Do State Idling Rules Say?
Idling rules vary by state and city, and this is general information and not legal advice. We read the texts through a legal-text mirror, not the official registers.
- California: diesel commercial vehicles over 10,000 pounds may not idle more than 5 consecutive minutes at any location, with exemptions such as traffic delays and powering equipment.
- New York State: heavy-duty vehicles may not idle more than 5 consecutive minutes when not in motion, with an exemption for powering an auxiliary purpose such as loading or discharging cargo.
- New York City: idling is limited to 3 minutes, and 1 minute next to public schools and parks, unless the engine operates a loading, unloading or processing device.
The loading exemptions cover engines that power equipment, so a truck simply waiting at a dock is not clearly exempt.
What Should You Look for in a Tracking Layer for Dwell and Idling?
Five criteria separate tracking that records dots from tracking that explains a stop.
Does it detect arrival reliably?
Ask for the update interval and the geofence radius, and how often an arrival is missed.
Can it use engine data?
Ask whether engine-on time and engine hours are an input, and from which device.
Does it report dwell by facility?
Ask for dwell per stop and per site, with a trend, so the waiting sites are visible.
Does it link dwell to the plan?
Ask whether dwell is compared with the planned service time and the promised window.
Can you export it?
Ask for an export that fuel and emissions reporting can use, with the definitions of each event.
How Does Locus Fit Dock Dwell and Idling Tracking?
Locus, the world’s first Decision-Intelligent, Agentic TMS, fits where a wait must be tied back to the plan, because it compares planned and actual performance, flags unplanned halts and checks promised windows against capacity.
Its published facts on this topic:
- Alerts for unauthorized route deviations, unplanned halts and temperature fluctuations in its control tower.
- Predictive ETAs powered by traffic data and driver telemetry.
- Plan-versus-actual performance analytics across routes, drivers and hubs, including SLA adherence and on-time trends.
- A route planner that works with service times, time slots and driver availability across 250+ constraint parameters.
- Delivery slots checked against live capacity, so a window is offered only when the network can keep it.
- Hub operations that aim to reduce time under the roof, with scanning and alerts at each milestone.
These are not a ranking of vendors, which no analyst publishes. Dwell, idle and engine-hours reporting come from telematics or an electronic logging device, and door-level dock scheduling sits in a warehouse or yard system.
Recognized by analysts and selected after evaluation. Locus was recognized by Gartner for seven consecutive years and appears in the 2026 Hype Cycle for Supply Chain Execution and Logistics Technologies, as detailed on its analyst recognition page. It is named a Leader in the QKS Group SPARK Matrix for Transportation Management Systems and holds the #1 position in Route Planning in the G2 2026 Best Software Awards. In October 2025, Ingka Investments, the investment arm of Ingka Group, the world’s largest IKEA retailer, acquired Locus. Ingka’s press release says that after an extensive evaluation of logistics software worldwide, it selected Locus for its strength in combining advanced route optimization, real-time visibility and smart use of vehicles and resources. Locus continues to operate independently.
| Tracking need | What Locus publishes |
|---|---|
| Halts and deviations | A control tower with alerts and plan-versus-actual analytics |
| Live position and alerts | Track and trace across fleets and carriers |
| Service-time-aware plans | A route planning system with time slots and service times |
| Keepable windows | Delivery promise management with capacity-checked slots |
| Hub flow | Automated hub operations with scanning |
For leaders asking what tracking shows about dock dwell and idling, the answer is arrival and departure times, with engine state and fuel from telematics. Locus fits where those waits need to be compared with the plan and the promise. To test your own stops, schedule a demo.
How Was This Guide Written?
This guide draws on ATRI, DOE, EPA, GPS.gov, the University of Washington Urban Freight Lab, the federal ELD rule and state idling texts, plus Locus’s product pages, read on November 18, 2026. The fuel and CO2 figures are our arithmetic on cited inputs and are illustrative.
We found no federal or ATRI detention release after September 2024, and no medium-duty idling rate from a primary source. The ATRI figures cover for-hire trucking and are not for van last mile. Competitors are not named. We review the guide every 30 to 60 days.
What Mistakes Do Teams Make Measuring Dwell and Idling?
Four mistakes recur.
Treating detention as idling. Detention is time lost, and idling is fuel burned, and they differ.
Applying a truck rate to a van. The 0.8 gallons per hour is for long-haul combination trucks.
Trusting a geofence that never fires. A slow update interval can miss most arrivals.
Assuming the loading exemption covers waiting. The state exemptions cover engines that power equipment.
Frequently Asked Questions
How often are drivers detained at stops? ATRI reports that drivers were detained in 39.3% of all stops in 2023. The release gives no duration for that figure.
How much fuel does idling use? DOE says idling a heavy-duty truck consumes about 0.8 gallons per hour. We found no primary rate for medium-duty vehicles.
How much CO2 is an hour of idling? About 8.2 kg for a heavy-duty truck, at 0.8 gallons and EPA’s 10.21 kg of CO2 per gallon of diesel. It is an illustration.
Can GPS tracking measure idling? Not directly. Phone GPS shows arrival and departure, and engine-on time comes from the engine computer through an electronic logging device or telematics.
Are there US idling limits? They vary by state and city. California and New York State set five minutes, and New York City sets three, with exemptions. This is not legal advice.
What did the University of Washington study find? Urban commercial vehicles spent 80% of their daily operating time parked, in a small Seattle sample of 6 ride-alongs and 79 stops.
Does Locus measure engine hours or idle time? Its pages describe unplanned-halt alerts, plan-versus-actual analytics and capacity-checked slots. Engine hours and idle time come from telematics.
How should you start? Define arrival and departure events, test your geofences, add engine data, measure dwell by facility and convert idle hours with stated assumptions.
Anas is a product marketer at Locus who enjoys turning complex logistics problems into simple, clear stories. Outside of work, he’s usually unwinding with a book or catching a good movie or series.
From GPS Pings to Freight Emissions: What Tracking Data Supplies for SmartWay and GHG Protocol Reporting
GPS tracking supplies distance and shipment detail for freight emissions, but not fuel, load or carrier intensity. What SmartWay, GHG Protocol and GLEC need from tracking, and what carriers must add.
Real-Time EV Tracking in US Last Mile: State of Charge, Range and Charge Status as Live Visibility Signals (2026)
Position tracking shows where an electric van is, not whether it can finish the route. How state of charge, range and charge status work as live signals in US last mile, with DOE, NREL and a delivery-van pilot.
Insights Worth Your Time
The Emissions You Can See Only in Tracking: Dock Dwell, Detention and Idling at US Stops (2026)